Connecting to Fologram for Rhino
On your PC, Follow the steps to install Fologram for Rhino if you haven't already done so.
On your PC, Launch Rhino and start Fologram.
On your phone, ensure you are connected to the same WiFi network as your PC running Rhino.
When you see the video stream and 'look at the QR code' prompt, point your phone's camera at the QR code displayed on your PC to connect.
Note: for best results hold your phone steady and try to avoid glare and reflections on the PC screen when connecting.
Detecting surfaces and placing models
Once you have connected to Fologram for Rhino, Fologram will use your phone camera to begin detecting surfaces for model placement. Look around the room with your phone to assist with this process. A target will indicate any available placement locations.
Note: black and blank surfaces can be difficult to detect. It may take some time to detect surfaces on older devices.
Tap on any point on a detected surface to place the 0,0,0 point of your Rhino model.
Tip: make sure your model is at an appropriate scale (e.g. a size that can be seen through your phone)! You can follow this guide for help with setting up a model for mixed reality.