Streaming the test model to the Oculus Quest
Make sure your Oculus Quest and PC are on the same WiFi network and Start Rhino on your laptop or PC. Type ‘Fologram’ into the command line in Rhino to open the Fologram plugin window, then click on the Connect a Device button to make your Rhino session discoverable to the Quest. A QR code will appear on your screen, however you can ignore this. Put on your Quest and open Fologram in the device.
Once the application has loaded, you will see a menu asking to ‘Connect to a Rhino Session’. Below this you will see a list of active Rhino sessions you can connect to. Find the session with your PC’s username, press connect and your model will load.
If you do not see your PC’s username, press ‘Enter IP Address’, and manually enter the IP address associated with your PC. This information can easily be found on the Connection QR code that appears after pressing ‘Connect a Device’ in Rhino.
Once you've connected, your model should load with the origin point at floor level in front of you. If you run into any issues at any of these steps, check out the troubleshooting help on our Community.
Comments
0 comments
Please sign in to leave a comment.